User avatar
By WelshPaul
Posts Signature Likes Avatar Topics
The following guide will help configure your Snom phone with your account.

IMPORTANT: Before you start configuring the device, make sure your device has the latest firmware installed and preform a factory reset. Once you have done that, proceed...

To configure your Snom phone you'll need your port5060 SIP Proxy, Username, Password and STUN Server information. Don't know them?
Get them here:

For the purpose of this guide I am going to use the following dummy information: SIP Credentials SIP Credentials
port5060-credentials.png (25.96 KiB) Viewed 3801 times

Now that you have updated your devices firmware, factory reset it and have your account information to hand you need to login to the Snom's web GUI. To do this, simply open your browser of choice (e.g. Chrome) and enter the IP address of your Snom device in the URL field. If a password has been set you will be prompted to login as shown in the image below.

Snom Login
Snom Login
Snom-login.png (77.72 KiB) Viewed 3801 times

Now configure the device as shown below...

Identity 1 (Login Tab)
  • Identity active: on
  • Displayname: p123-p123craig123
  • Account: p123-p123craig123
  • Password: 12345678
  • Registrar:
  • Outbound Proxy:
  • Authentication Username: p123-p123craig123
Snom Identity Configuration
Snom Identity Configuration
Snom-Identity-1.png (52.52 KiB) Viewed 3800 times

Click on the "Apply" button...

Identity 1 (NAT Tab)
  • STUN Server (IP-Address:Port):
  • STUN Interval (s): 30
  • Keepalive Interval (s): 15
Snom NAT Configuration
Snom NAT Configuration
Snom-NAT.png (17.42 KiB) Viewed 3800 times

Finally click on the "Apply" button. Your device will now register with your account. Login to your account and confirm that the device status is showing "Online". Extension Status Extension Status
Port5060-status-2.png (27.66 KiB) Viewed 3799 times

That's it! You have successfully configured your Snom IP Phone with Now go make some calls! 👍

My HT801 was configured for another UK provider. I rea…

Sip to PSTN lines gateway

Hi All I am looking for a gateway that will allow a le…

Hi all! We have Cisco 7941 phones that we are battlein…

TalkTalk -residential VOIP

Do not touch it. No incomming caller ID no call rou…

Sign up for VIP membership