The Panasonic NS-700 supports SIP The SIP trunking services through virtual CO line cards so there should be no need to replace any hardware. Does your Panasonic NS-700 have a V-SIPGW16 card installed? If it does, get yourself a suitable SIP trunk and configure a virtual slot on the Panasonic NS-700 to use it!
As an example, I have included below a basic guide showing how to configure a Panasonic NS-700 for use with Voipfone.co.uk:
STEP 1
Log in to your NS-700 web interface, you will be initially greeted with this screen:
NS700-1.png (103.14 KiB) Viewed 808 times
STEP 2
Select a virtual slot and then click and drag a
V-SIPGW16 card to the trunk rack, slot 1:
NS700-2.png (112.41 KiB) Viewed 808 times
STEP 3
Put the card into "
Out of Service" mode by selecting Ous:
NS700-3.png (137.9 KiB) Viewed 808 times
STEP 4
Through the same menu used to put the card into "
Out of Service"mode, navigate to the "
Port Property" menu. Under the "
Main Tab" put the "
Provider Name" as "
SIPTRUNK" and the "
SIP Server Name" as "
sip.voipfone.net":
NS700-4.png (198.18 KiB) Viewed 808 times
STEP 5
Make sure the port is set to
5060 and input the "
SIP Service Domain" as "
sip.voipfone.net" and the "
Subscriber Number" to "
Your Voipfone account number (the 8-digit number starting with 3) followed by star and your 3-digit extension number",
CLICK APPLY.
NS700-5.png (195.39 KiB) Viewed 808 times
STEP 6
Navigate to the "
Account" Tab. This is where you will enter your trunk registration information into Virtual Slot 1.
- User Name= Your Voipfone account number (the 8-digit number starting with 3) followed by star and your 3-digit extension number
- Authentication ID= Your Voipfone account number (the 8-digit number starting with 3) followed by star and your 3-digit extension number
- Authentication Password= Your Voipfone extension account password
CLICK APPLY
NS700-6.png (173.9 KiB) Viewed 808 times
STEP 7
Navigate back to the menu where you selected "
Port Property" and select "
Shelf Property".
- SIP Client Port Number = 5060
- NAT - Voice (RTP) UDP Port No. = 16000
- NAT - Keep Alive Packet Sending Ability = Enable
- NAT - Keep Alive Packet Type = Blank UDP
- NAT - Keep Alive Packet Sending Interval = 20
- NAT - Fixed Global IP Address = YOUR PUBLIC IP
- Stun Ability = Disable
CLICK APPLY
NS700-7.png (152 KiB) Viewed 808 times
STEP 8
Navigate to the "
Network Service" menu on the left. Under that menu select "
IP Address/Ports". On this screen you will configure your LAN with
STATIC IP/DNS/DSP IP.
CLICK APPLY
NS700-8.png (141.65 KiB) Viewed 808 times
NS700-9.png (110.62 KiB) Viewed 808 times
STEP 9
Finally, reset your system by navigating to the System Control menu on the left.
NS700-10.png (55.27 KiB) Viewed 808 times