If it's about VoIP, SIP or Internet Telephony but it doesn't seem to fit anywhere else, post it here.
User avatar
By ming1340
Posts Avatar Topics
#5434

Hello every body,

I am newbies here and i meet the problem on FoIP message. I would like to discuss about the FoIP Message is abnormal or not if the "m=image 0 udptl t38 " ? If the Port = 0 , is it mean that we can't make the session between me and remote end ?

Here is the full message :
CSeq: 1 INVITE
Contact: <sip:172.26.34.117:5060>
Supported:
Allow:ACK,BYE,CANCEL,INFO,INVITE,OPTIONS,PRACK,REFER,NOTIFY,UPDATE
Accept:application/dtmf-relay,application/media_control+xml,application/sdp,application/x-broadworks-call-center+xml,multipart/mixed
Content-Type: application/sdp
Content-Length: 267

v=0
o=BroadWorks 167077 2 IN IP4 172.26.34.117
s=-
c=IN IP4 172.26.34.117
t=0 0
m=audio 20434 RTP/AVP 8
a=sendrecv
a=rtpmap:8 PCMA/8000
a=ptime:20
m=image 0 udptl t38 :devil:
a=T38FaxVersion:0
a=T38FaxRateManagement:transferredTCF
a=T38FaxUdpEC:t38UDPRedundancy

Thank you.

User avatar
By WelshPaul
Posts Signature Likes Avatar Topics
#5436
Hi @ming1340 ,

While i'm no fax guru, everything looks normal in the above INVITE. :thumbsup:
ming1340 wrote:If the Port = 0 , is it mean that we can't make the session between me and remote end ?
Port 0 is a reserved port in TCP/IP networking, meaning that it should not be used in TCP or UDP messages.

I have two asterisk servers (1 running asterisk (box1) …

Sipgate Basic and multiple SIP clients

Ok, thanks. Was worried that using the same sip user in…

Your device was probably listed on Cisco's provisioning…

This means it is very dangerous to post here other t…

Sign up for VIP membership