If it's about VoIP, SIP or Internet Telephony but it doesn't seem to fit anywhere else, post it here.
User avatar
By mgray
Posts Avatar Topics
#6557
Do any of the experts here know how to set the outgoing line with speed dial. I am using SPA 504G with attendant console and have four lines UK US France and Australia sip lines The SD fnc=sd;ext=+XXXXXX will always dial with the first line - I would like to add a string (if it exists) to select the outgoing line. Any ideas?
0
User avatar
By WelshPaul
Posts Signature Likes Avatar Topics
#6558
Just add vid=# to the end of your speed dial syntax.
(Replace # with 1 for EXT 1 or 2 for EXT 2 etc)

Example:
Code: Select all
fnc=type;sub=stationname@$PROXY;ext=extension#@$PROXYvid=#
0
0
0
User avatar
By WelshPaul
Posts Signature Likes Avatar Topics
#6561
Have you tried simply modifying the "ext" syntax to use the domain or ip of your preferred VoIP provider?

Lets say EXT 1 is configured to use Voipfone and EXT 2 is using Sipgate then maybe try:
Code: Select all
fnc=sd;ext=123@sipgate.co.uk
Press the speed dial button and it should dial 123 over Sipgate.
0

My HT801 was configured for another UK provider. I rea…

Sip to PSTN lines gateway

Hi All I am looking for a gateway that will allow a le…

Hi all! We have Cisco 7941 phones that we are battlein…

TalkTalk -residential VOIP

Do not touch it. No incomming caller ID no call rou…

Sign up for VIP membership