If it's about VoIP, SIP or Internet Telephony but it doesn't seem to fit anywhere else, post it here.
User avatar
By drifting
Posts Avatar Topics
#3855
Hi .

I am messing with a couple of raspberry Pi, which are running a open source version of the SAIL PBX system.
Problem was that I could never get two way communications with an IAX trunk. Just by messing around and googling I found an article that mentioned changing the trunk=yes to no and lo and behold it now works! What is the implication of making such a change, as of yet, and lots of searching I have not really found an answer.

Regards Drift
User avatar
By WelshPaul
Posts Signature Likes Avatar Topics
#3856
Perfectly safe, you're basically turning off trunk mode, see: http://www.voip-info.org/wiki/view/Aste ... width+iax2

You need to use the "trunk=no" line in your conf file when your provider uses a service such as load balancing. If you use "trunk=yes" then as you already found out, you will experience issues with one way audio.
Sipgate Basic and multiple SIP clients

Ok, thanks. Was worried that using the same sip user in…

Your device was probably listed on Cisco's provisioning…

This means it is very dangerous to post here other t…

https://www.ukvoipforums.com/viewtopic.php?t=58#p5950

Sign up for VIP membership